| Model | F-600 (24V / DC) |
|---|---|
| Rated power supply (V) | 230V AC 50 / 60Hz |
| Motor voltage (V) | 24DC |
| Input power (W) | 100 |
| Ambient temperature (℃) | -20 ~ +50 |
| Maximum door weight (kg) | 350 |
| Maximum Width (M) | 2.5 |
| Maximum opening angle (°) | 120 |
| Maximum stroke (mm) | 350 |
| Maximum opening area (㎡) | 20 |
SAFETY REVERSAL
RIO-S control panels apply lower power in the slowed down end of travel zone. The pressure builds up indicating a physical end of travel, then the power is shut off. AVANTI has adjustable rubber stops fitted under the shaft set at each end of travel. The closed and open stops can be replaced by a gate centre stop oand open stops. Stroke length can be increased by 50mm by removing the adjustable stops, but this will not increase the gate opening angle.
ADJUSTABLE STOPS - MANUAL RELEASE
There is a manual release key point in the top of the opener. For open barred gates, this release is accessible through the bars. For security, the release key is a unique 5 faced type. Rotate by half a turn to de-clutching the motor allowing the gate to be pushed open by hand. After manual release, the gates the control panel power should be switched off.
CONTROLS
AVANTI sets come with two double button remotes. Channel 1 opens the gate fully. The other channel can optionally be set to partially open the gate for pedestrians, or to operate another device such as a garage door or gate. The full open function is also available as a hardwire input for a wired keypad on intercom.
BATTERY BACKUP
OPERATION
AVANTI motor speed ramps up to spped in mid travel, then decelerates to the end of travel. This soft start and stop is automatically set during programming. Stop positions are set by physical limits on the shaft, or by the gate's end of travel. The maximum swing of a ram is 120 degrees for very light gates, but this depends on geometry.
The RIO-S control panel features amperometric PSR (pressure sensitive reversal but current sensing). If the gate is slowed by an external force, such as meeting an obstacle, the current in the motor increases. RIO-S senses the unexpected change, stops the gate, then reverses it.
Standard sets include a photobeam and two remotes. There are photobeam inputs for re-open and for stop in either direction. Additional safety devices may be required following a risk assessment.
